🎭Entertainment > Showtime

Linking sending recieving units

(1/1)

Curby:
Ok after much searching and trial and error I got all of my X10 software installed and running i have my sender and reciever 3 inches apart when i turn the sender off my tv goes static when i turn the unit on it says signal unusable and ideas?

HA Dave:

--- Quote from: Curby on January 31, 2008, 02:03:47 AM ---Ok after much searching and trial and error I got all of my X10 software installed and running

 i have my sender and reciever 3 inches apart when i turn the sender off my tv goes static when i turn the unit on it says signal unusable and ideas?

--- End quote ---

Do you plan to run the cameras via software/computer.... or on the TV or both?

I will have to assume... you have a working camera turned ON and connected to the sender unit.... and that the receiving unit is properly connected to the TV. First make sure your cables are OK... and that both the sender/receiver are set to the same channel. Try changing the channels (both on "B"... or both on "D").

Navigation

[0] Message Index