🎭Entertainment > Showtime

Showtime software and X10 remote


Anyone have an issue with the X10 remote control included with the Showtime software and Video Sender where it skips the even photos?  When I start a slide show it will show all the odd photos (but flashes the even photo just before showing the next odd picture) and then after showing all of the odd photos shows the even photos.  Thoughts?  Ideas?

I am having the same problem. When you just arrow over to the next photo, it flashes #2 and goes right to #3. This has been read over 1100 times, with no answer. Not very encouraging. Obviously others must have this problem, but no solutions. My Harmony used to do this, but you could change settings to "slow" it down.


[0] Message Index

Go to full version