Please login or register.

Login with username, password and session length

Author Topic: How do I ...  (Read 7129 times)

mattie

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 6
How do I ...
« on: May 16, 2008, 05:51:49 PM »

 get my cameras to mate up with this system? I have the Vangaurd system with 2 XX20A B&W ,and 2 XX16A Color, with 4 MS14A motion sensors hooked up to my PC with the VA11A and the VR24A. I can get one to mate up with a good picture and thats it.
   I have them all set with the same HOUSE "A" and then each camera is set up with a different UNIT "1-4". When I switch the VR42A button on the bottom from A to D it will pick up another camera but it wont keep a good connection. All fuzzy and it wont go to a live feed. Like I said..I can get House A Unit 1 to connect with a good picture and thats the only one.
    I tried to ask this in the wireless camera section but not to many guy there were familiar with the Vangaurd system.Thanks in advance
 
Logged

zach1234

  • Guest
Re: How do I ...
« Reply #1 on: May 16, 2008, 11:16:55 PM »

Well, I am guessing you aren't able to switch threw cameras?

If so you need a Active home interface or a transceiver (alarm consol works too).
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.