Sometimes when other commands are executing, a sensor state may get missed by the CM15A - I'm finding that if a macro is firing, I sometimes don't get an OFF from a motion sensor.
e.g. I have 2 DS10a's in the garage which set a "DOOR OPEN" flag and turn on a light when a door is opened. I had them test that both doors were closed before turning OFF the light - So each time either sent its CLOSED heartbeat, they'd run a macro to turn off the light. If it was on, it went off, if it was already OFF, I figured what the heck, another off command won't hurt. Same thing when opening either door - send the ON command even if it's already on. WRONG - when the OFF macro was running today at exactly the moment my MS14 was sending an RF OFF, the RF OFF never made it to the CM15a.
Since I was using a flag to indicate a garage door open anyway, I just added that condition to the "Closed" and "Triggered" macros - now they only execute when the flag is SET (or not). 4 - to- 6 commands NOT sent every hour or when a door is opened if the light is already on.
Just a piece of advice...
Author
Topic: Advice - Reduce traffic via FLAGS & Conditions (Read 3229 times)