Please login or register.

Login with username, password and session length

Author Topic: Starting a macro with a timer  (Read 6193 times)

thejfk

  • Full Member
  • ***
  • Helpful Post Rating: 1
  • Posts: 49
Starting a macro with a timer
« on: October 22, 2008, 01:22:50 AM »

To start a macro with a timer, should I just use a dummy module trigger"OFF".
and a  macro start timer. (B1 trigger-OFF-macro timer starts a 6:00am)
 
Or should I use a  dummy module and use its timer  "ON" to start the macro (B1 ON trigger--B1 phantom module on at 6:00 am to trigger macro)

Is there a way to set up a macro with just a timer as the trigger, rather than the HC/UC?
Thanks
Logged

Boiler

  • Guest
Re: Starting a macro with a timer
« Reply #1 on: October 22, 2008, 12:50:43 PM »

If you look in the lower right corner of your macro Icon, you'll see a small "clock" symbol.

Left click on the clock and it will bring up the "timer designer".  Once a timer has been set, the clock symbol will be shown in green.

« Last Edit: October 25, 2009, 05:16:14 PM by Boiler »
Logged

thejfk

  • Full Member
  • ***
  • Helpful Post Rating: 1
  • Posts: 49
Re: Starting a macro with a timer
« Reply #2 on: October 22, 2008, 06:37:24 PM »

Thanks Boiler,
That's what I did and it works fine, But I don't have or need a trigger(besides the timer), so I just put B1 in the box and checked OFF. I don't have any "B" modules or even a B1 dummy.
It would be nice if in the trigger box, you could enter "timer"
Logged

Boiler

  • Guest
Re: Starting a macro with a timer
« Reply #3 on: October 23, 2008, 03:47:50 PM »

Now I understand your question (Homer Slap).

You're correct that AHP wants a trigger of some sort specified. It would be nice to be able to enter "none", but that's not an option.

Assigning the macro to an unused House/Unit code is the best option here.
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.