Please login or register.

Login with username, password and session length

Author Topic: ms14a and ws467 dimmable  (Read 3845 times)

tuckerssb

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 1
ms14a and ws467 dimmable
« on: January 03, 2009, 06:23:16 PM »

I originally had a transceiver module, wall switch and eagle eye. we had a lightning strike which killed the transceiver and wall switch.
I upgraded to AHPro, and a new dimmable ws467.

I cannot get the ws467 to respond to commands sent from the eagle eye. I have put fresh batteries everywhere, checked codes in eagle eye and still have no luck. Both the eagle eye and the ws467 are set to F2.

help??
Logged

Brian H

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 305
  • Posts: 13259
Re: ms14a and ws467 dimmable
« Reply #1 on: January 03, 2009, 07:48:05 PM »

In AHP. Tools tab. Hardware Interface Configuration. Make sure that your F House Code is set to be Transceived. If not the RF signal from the motion sensor will never be sent over the power line to the wall switch. Mine I believe defaulted to Auto and only A was enabled.
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.