Please login or register.

Login with username, password and session length
Advanced search  


The Buster PiX10Hub is here! Created by the Community, for the Community.:)% #:)

Pages: 1 [2]

Author Topic: AHP not updating when switches are turned on.  (Read 6758 times)


  • Hero Member
  • *****
  • Helpful Post Rating: 6
  • Posts: 195
  • M M Electric
Re: AHP not updating when switches are turned on.
« Reply #15 on: December 28, 2009, 08:24:00 PM »

The best way to do what you want is to let the controller do all the switching..
And use wired wall controllers where the switches would go. That way every time you
use them they send a command out to the controller to do so.  that will update the
system as to what state each light is at

It will take some rewire and device change out.
Although if your system is stable it could greatly enhance it.
With the ability to controll up to four addresses from each switch
M M ElectricMan


  • Hero Member
  • *****
  • Helpful Post Rating: 21
  • Posts: 428
    • PHP Web Scripting
Re: AHP not updating when switches are turned on.
« Reply #16 on: December 30, 2009, 11:22:58 PM »

Well, what I think I am going to do is use the switches I currently have in less used places where it won't matter as much and get some higher end switches for the main part of the house.  I am currently working on setting up BVC to work with my setup, but I will get back to installing those switches soon enough.

I want to thank all the people in here for the excellent input on this topic.

Dan Bemowski
Owner of PHP Web Scripting LLC
Programmer of RemoteWatch X10
User of any X10 products I can get my hands on.
Pages: 1 [2] | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 All rights reserved.