Please login or register.

Login with username, password and session length

Author Topic: Solved: Switch shows on in AHP, but brightness is zero percent  (Read 1904 times)

peg-leg

  • Sr. Member
  • ****
  • Helpful Post Rating: 11
  • Posts: 111

Solved: Dummy me had unchecked Transceive house code A in the AHP hardware config menu.

I'm seeing an intermittent problem with my hr12a remote and AHP.  I've noticed at times certain lights won't turn on while others will.  I've been thinking this was a signal problem caused by some type of interferance.  Generally if I wait 30 minutes to an hour, the problem resolves itself.

Tonight the problem happened again so I I decided to monitor what was occuring by viewing the switch status in AHP.  When I press button one on my hr12a, switch A1 flips "on", but the brightness level stays at zero percent.  I checked my preferences and "issue on in place of brightness" is selected.

My switches are ws467's and ws4777's, all labeled as lm14a's to solve the compatablity problem with AHP.  I'm using ver 3.228 of AHP.

Any ideas as to what's causing my problem?

Thanks.
« Last Edit: September 01, 2010, 10:05:56 PM by peg-leg »
Logged

Dan Lawrence

  • Hero Member
  • *****
  • Helpful Post Rating: 68
  • Posts: 3991
Re: Solved: Switch shows on in AHP, but brightness is zero percent
« Reply #1 on: September 12, 2010, 02:38:44 PM »

Did you ever get your problem solved?
Logged
I don't SELL this stuff... BUT I sure do ENJOY using it!!!

peg-leg

  • Sr. Member
  • ****
  • Helpful Post Rating: 11
  • Posts: 111
Re: Solved: Switch shows on in AHP, but brightness is zero percent
« Reply #2 on: September 12, 2010, 05:27:33 PM »

Yes.  Thanks for checking.
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.