Please login or register.

Login with username, password and session length
Pages: 1 [2]

Author Topic: Macro Running for No Reason  (Read 11713 times)

ckjk616

  • Jr. Member
  • **
  • Helpful Post Rating: 0
  • Posts: 22
Re: Macro Running for No Reason
« Reply #15 on: September 21, 2010, 08:28:00 AM »

In response to Noam's post, I rethought it and realized you were right about a macro running to check conditions, but that wasn't what was happening. The first macro ran, turned on it's dummy switch to set off the second (the one with the conditions), but the first refired just as the second went off. To my knowledge, a macro doesn't flash when it has finished. Until the first was finished, now running for the second time, the macros couldn't be run again, even though the second had run and completed, either stopping due to conditions not being met, or continuing to the end if they have. Thanks, Jeff
Logged

ckjk616

  • Jr. Member
  • **
  • Helpful Post Rating: 0
  • Posts: 22
Re: Macro Running for No Reason
« Reply #16 on: September 21, 2010, 07:38:05 PM »

It's Working!!!! It must have been the reload of the software, but I can't be sure. As far as I know, I rewrote the new "entry lights" macros exactly as I did before, and now they're working. Many thanks for all your suggestions and interest. Best Regards, Jeff
Logged
Pages: 1 [2]
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.