Please login or register.

Login with username, password and session length
Advanced search  

News:

The X10Hub (PiX10Hub) is here! Created by the Community, for the Community.:)% #:)

Author Topic: Macro Not Working  (Read 3435 times)

SPSACH

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 4
Macro Not Working
« on: October 11, 2010, 10:03:26 PM »

I have a simple macro to turn on a light using WS467 Switch when a sensor detects motion, delay for 2 minutes and then turn it off. However it is not working even when I see the Icon on the ActiveHomePro turns green

TRIGGER CONDITIONS A1 ON and
Module Status On - DuskSwitch (A14 - Turned on at dusk and off at dawn)
End Trigger Condition
Turn GarageSwitch (D2) On
Wait for 2 minutes
Turn GarageSwitch (D2) Off
Store in Interface

I have looked at the activity Monitor. Here is what it shows:
A1 On
D2 (GarageSwitch)
D Bright 100% (GarageSwitch)
D2 (GarageSwitch)
A1 Off
D2 (GarageSwitch)
D Off

It has functioned a few times but is very erratic.

I'd appreciate any help
Logged

-Bill- (of wgjohns.com)

  • Advanced Member
  • Hero Member
  • ******
  • Helpful Post Rating: 81
  • Posts: 1340
  • He's just this guy. You know?
    • wgjohns.com
Re: Macro Not Working
« Reply #1 on: October 12, 2010, 01:13:16 AM »

Under Tools-Preferences...  Macro Options tab.  Make sure "Issue 'On' in place of 'Bright 100%' " is checked.
 >!
Logged
-Bill- (of wgjohns.com)
bill@wgjohns.com

In the real world, the only constant is change.

When I'm online you can find me in the Home Automation Chat Room!
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.