Please login or register.

Login with username, password and session length
Pages: 1 2 [3]

Author Topic: Question for those using the CM11A for PC-based automation software  (Read 40954 times)

JeffVolp

  • Moderator
  • Hero Member
  • *
  • Helpful Post Rating: 122
  • Posts: 2285
    • XTB Home Page
Re: Question for those using the CM11A for PC-based automation software
« Reply #30 on: August 09, 2011, 07:36:44 PM »

Near the bottom of the link I gave. Is a explanation of with is sent when it wants to know its last know state and what the CM11A sent back.

Ah, after going through it again, I see that does define the data and command bytes received from the LM14A following the power-up (10 & 37) is the extended status request. 

The response is the extended configuration data and command bytes (02 & 3B), which has the auto-acknowledge "standard" bit set.

Anyway, the communication through the XTB-232 agrees with the X10 documentation.

Jeff
Logged
X-10 automation since the BSR days
Pages: 1 2 [3]
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.