X10 AirPad Android Tablet > AirPad General Discussions

AirPad XL Image

(1/6) > >>

X10 Repair Depot:
These instructions and the image files are designed only for the Airpad XL. This unit is labeled CM008 on the back cover of the unit. Do not attempt to install this software on any other unit.

By updating the operating system you will loose all data and apps. Backup everything before proceeding.


NOTE: This is the version that was originally installed on the AirPad XL. It should only be used to recover a non-working unit.

This is a link to the the image file:

THIS LINK HAS BEEN CORRECTED, AND IS THE PROPER FIRMWARE FOR THE XL
ftp.x10.com/pub/applications/airpad_xl_cm008-0107.rar

Use the instructions listed in this thread to install it:

http://forums.x10.com/index.php?topic=26336.0

android7.ip:
Just want to double check.  You mentioned that the firmware is for the CM008, which is the Airpad XL 10 inch tablet.  However, the file name on the link you posted is airpad_7p_cm007_ICS.20120307.rar, and the instructions link points to the instruction for the 7p upgrade.

Are these the correct file and instructions for the XL 10 inch tablet?

Thanks

cyphon:
I was on 4.0.1 from the manufacturer's website.  Which we all know is very buggy.  I attempted to roll back to this release to get back to factory config.  However, after applying the update, I cannot get any display.  I can see the screen turn on (back light) but no display. Tried multiple times.  Everything indicates that it was applied successfully.  I also have consurns about the version, since the filename indicates this is ICS and not Gingerbread.

gjf:
I think the link to the XL firmware should be what I found below?
Can X10 repair Depot comfirm this link?


http://ftp.x10.com/pub/applications/airpad_xl_cm008-0107.rar

GJF

X10 Repair Depot:
All,

Thanks for catching that bad link, and I appologize to anybody that installed it. The link in the first post has been corrected.





--- Quote from: cyphon on March 12, 2012, 08:15:30 PM ---I was on 4.0.1 from the manufacturer's website.  Which we all know is very buggy.  I attempted to roll back to this release to get back to factory config.  However, after applying the update, I cannot get any display.  I can see the screen turn on (back light) but no display. Tried multiple times.  Everything indicates that it was applied successfully.  I also have consurns about the version, since the filename indicates this is ICS and not Gingerbread.

--- End quote ---

Cyphon,

Download and install firmware in the corrected link, and your unit should be up and running again. If you have any problems, please let me know.

Navigation

[0] Message Index

[#] Next page