Please login or register.

Login with username, password and session length

Author Topic: SC1200 Fire Module  (Read 4286 times)

idunham

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 1
SC1200 Fire Module
« on: June 15, 2012, 08:29:07 AM »

Has anyone ever put a Fire sensor, Water Sensor, or a Carbon Monoxide sensor on the SC1200? Obviously X10 doesn't sell these type of modules for the SC1200, but has anyone found anything i can 'add on' to the system?

Thanks!
Logged

dave w

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 139
  • Posts: 6116
Re: SC1200 Fire Module
« Reply #1 on: June 15, 2012, 10:24:32 AM »

The short answer is: any stand alone externalsensor (smoke, fire, water, etc.) that has a "NO - NC" output (normally open - normally closed) will work with the DS12 security Sensor. The NC contacts of the external sensor would connect to the internal input terminals (second input) of the DS12A. When the external sensor triggers, the NC contacts of the added sensor will open which will trigger an alarm signal from the DS12A. Look for add on sensors that provide selectable contact open or contact close upon trigger.

Also there are many hacking instructions on the forum for addapting DS12A and DS10A sensors to water and smoke detectors. Search the forum with terms like "DS10 (or DS12A)water leak detector" and "smoke detector" etc.
Logged
"This aftershave makes me look fat"

Brian H

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 305
  • Posts: 13259
Re: SC1200 Fire Module
« Reply #2 on: June 15, 2012, 10:36:33 AM »

Since the DS12As connector for an external set of NC contacts is a separate zone. You could use both the built in magnetic switch and the external zone. Registering each one as a separate zone if you cared to.
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.