🎭Entertainment > iconRemote

onkyo receiver TX-NR807 OR HTRC180

(1/2) > >>

geponchuk:
ONKYO code will turn on, but not turn off the receiver.  tried the learning process. power button always a failure. Does anyone know the code or how to program the remote. It is a model IR34A. thanks in advance

dhouston:
I have no idea as far as the proper code for your Onkyo gear but some manufacturers use the same code for On & Off - if Off, it turns on and vice versa. It might be worth a try here.

geponchuk:
as i said, it will turn on with the codes, but it will not turn off with the same code..  also it will not learn the codes when you hold them next to each other. any other ideas????

Brian H:
The IR34A in the learing mode. Uses a sensor in the back of the remote.
Are you pointing the sender of the original remote at the rear of the IR34A?

I have also found the exact pointing of some remotes at the back can be touchy.
I have had to raise or lower the original remote or IR34A. To hit the IR34As IR receiver squarely. In some cases.

geponchuk:
thank you. I was pointing at the front of the remote.  now it takes the power setting, but will only turn on not off.  I solved the problem by putting in the off code in another place.  Thanks for the help. the instructions do not tell you to put the remote at the back.  now how do you macro on all the devices at once without reprogramming. :)% :)% :)% :)%

Navigation

[0] Message Index

[#] Next page