Topic: Module works from AHP but not when macro runs (Read 3561 times)

bigmac · « **on:** August 06, 2012, 08:12:43 PM »

AHP 3.313
SMART MACROS
CM15A
RR501
X10 PRO PHASE COUPLER

I have a macro to turn on an appliance module (floor lamp) that will work when I manually turn it on in AHP or by the remote. When the macro runs it shows in AHP that it turns on and off as it should, but the module does not activate?

Thanks in advance.
Merle

dave w · « **Reply #1 on:** August 06, 2012, 09:00:38 PM »

Quote from: bigmac on August 06, 2012, 08:12:43 PM

I have a macro to turn on an appliance module (floor lamp)

If you are controlling an Appliance Module, why does the screen show it as a DIMMABLE lamp module?

Dan Lawrence · « **Reply #2 on:** August 06, 2012, 09:02:02 PM »

Quote from: bigmac on August 06, 2012, 08:12:43 PM

AHP 3.313
SMART MACROS
CM15A
RR501
X10 PRO PHASE COUPLER

I have a macro to turn on an appliance module (floor lamp) that will work when I manually turn it on in AHP or by the remote. When the macro runs it shows in AHP that it turns on and off as it should, but the module does not activate?

Thanks in advance.
Merle

Are you 100% sure everything is working the way you want and is setup correctly. The Activity Monitor is showing it works correctly. Where is the X10 Pro Phase Coupler mounted?

bigmac · « **Reply #3 on:** August 06, 2012, 09:31:06 PM »

Dave W: Very good question............I originally had an LM14a there. Once it started messing up I swapped out the module to see if it would correct the issue.

The coupler is wired in the breaker box. All other X10 products work properly (other than cameras, which I've pretty much given up on).

It just seems strange that I can operate the module from the remote or manually through AHP.

Noam · « **Reply #4 on:** August 06, 2012, 11:34:08 PM »

The macro is sending a "Bright 100%". The appliance module doesn't understand that, so it ignores it.
When you use the remote, it is sending an "on" command, that the module understands. When you manually turn it on in AHP, it also sends an "ON" command.
Change the module type from a "Lamp" to an "Appliance," and that should fix the macro.

dave w · « **Reply #5 on:** August 07, 2012, 07:25:30 AM »

What Noam said.

bigmac · « **Reply #6 on:** August 07, 2012, 09:00:39 AM »

Thank you NOAM. Changed module and that seems to have fixed it.

MM

News:

Author Topic: Module works from AHP but not when macro runs (Read 3561 times)

bigmac

Module works from AHP but not when macro runs

dave w

Re: Module works from AHP but not when macro runs

Dan Lawrence

Re: Module works from AHP but not when macro runs

bigmac

Re: Module works from AHP but not when macro runs

Noam

Re: Module works from AHP but not when macro runs

dave w

Re: Module works from AHP but not when macro runs

bigmac

Re: Module works from AHP but not when macro runs