Please login or register.

Login with username, password and session length
Advanced search  

News:

The X10Hub (PiX10Hub) is here! Created by the Community, for the Community.:)% #:)

Author Topic: Active Home AirSight Interface  (Read 3733 times)

tploy

  • Jr. Member
  • **
  • Helpful Post Rating: 0
  • Posts: 11
Active Home AirSight Interface
« on: August 01, 2012, 06:18:32 PM »

I recently purchased the new Airsight IP Outdoor Cameras and the Active Home Software package to control the Ninja Camera Base Interface to remotely position the Outdoor Cameras. It took a while to get everything set up and working But I've managed to get one of three units working as I want it to (the one closest to the transmiter attached to the computer). By using the Airsight Software to monitor the camera view and the active Home Iwatchout software to move the Ninja camera base.

However What I WISH for is to have the Iwatchout software be able to display the IP Video Feed From the Airsight Cameras It currently only will interface with the proprietary USB X10 Camera interface.

Also, I WISH that the signal from the Active Home Software Interface (CM19A) could be addressed to signal relay through the X10 Modules EX use one module as a signal receiver (RR501) and repeating it from another module (TM751) to transmit to another Ninja Base (VK74A) at a distance of around 550 ft (Maximum distance) Since I have cameras positioned covering more than an acre of land and can place additional Repeater modules near the Ninja units.
Logged

Dan Lawrence

  • Hero Member
  • *****
  • Helpful Post Rating: 68
  • Posts: 3991
Re: Active Home AirSight Interface
« Reply #1 on: August 01, 2012, 07:50:08 PM »

The CM19A has nothing like the CM15A did.   It needs a TM751 or a RR501 to put signals on the powerlline.
Logged
I don't SELL this stuff... BUT I sure do ENJOY using it!!!
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.