🖥️ActiveHome Pro > OnAlert
AHP mixing up signals
birdzeye:
Hi,
I just noticed that my KR10A and some other door/window sensors were not "installed" in AHP. When I tried to install the KR10A a note came up saying the signal was received but it was registered to one of my door/window sensors in the dining room! When I looked at the door/window sensor in AHP it was also not installed (even though I installed it correctly before) and the battery indicator light is showing in the module.
What is the correct procedure for replacing batteries and installing modules? Do you basically have to unplug the security console and do a fresh install of everything every time a battery needs replacement? Is there an easier "trick" to this thing?
P.S. I've been away from the X10 scene for awhile, so I'd like to just say I'm glad to see this website is still here, and hello to everybody!
Brian H:
What version of AHP?
Older DS7000/PS561 Console or the new SC1200?
Door/Window Sensors DS10A or DS12A?
Motion Sensors MS10A or MS18A?
If the batteries are not completely dead.
I believe you have a chance to change them as long as you don't have them out too long and have them keep their original IDs.
birdzeye:
It's the older version DS7000 and the window sensors are the old ones too. The AHP version is 3.228. No motion sensors.
Dan Lawrence:
3.228 does not accept Soft-Start modules properly. You need to upgrade.
birdzeye:
--- Quote from: Dan Lawrence on November 06, 2012, 06:49:01 PM ---3.228 does not accept Soft-Start modules properly. You need to upgrade.
--- End quote ---
OK thanks. Any suggestions as to which next version to upgrade to that's stable, and how? I've lost the page that had all the upgrade versions.
Navigation
[0] Message Index
[#] Next page
Go to full version