Please login or register.

Login with username, password and session length

Author Topic: My door sensors stopped working  (Read 4065 times)

jmonte

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 1
My door sensors stopped working
« on: January 12, 2014, 07:36:43 PM »

My door sensors stopped working. After reading trouble shooting in the manual, I reset them all. I pressed the test button on all the sensors. Went back to the console and switched it to install. I went back to each sensor and hit test again. I then set the console back to run 2. When I open the door, the light flashed, but no chime. This is on all the doors. :-\
Logged

Tuicemen

  • Administrator
  • Hero Member
  • ****
  • Helpful Post Rating: 282
  • Posts: 10497
  • I don't work for X10, I use it successfuly!
Re: My door sensors stopped working
« Reply #1 on: January 12, 2014, 07:43:14 PM »

I assume  your posting about a ds7000 or sc1200? ???
Logged
Please Read Topic:
General Forum Etiquette
Before you post!

Brian H

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 305
  • Posts: 13259
Re: My door sensors stopped working
« Reply #2 on: January 13, 2014, 06:10:46 AM »

Run 1, Run 2 and Install switch. So you have an X10 DS7000 Security Kit?

When you reset the door sensors. You changed their ID.
Did you also reset the console {unplug AC and remove the battery} so it could register the door sensors; keyfobs, tabletop remote  and have the switch in the Install Position?

Did the console Beep when you added the door sensors?

If it did not beep and in Run 2 no chimes. Either you didn't get the door sensors registered or the console has a problem receiving their signals.

Have you added any new electronic devices in the home, that maybe using an RF signal?
« Last Edit: January 13, 2014, 06:15:58 AM by Brian H »
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.