Please login or register.

Login with username, password and session length
Advanced search  


The Buster PiX10Hub is here! Created by the Community, for the Community.:)% #:)

Author Topic: Showtime software and X10 remote  (Read 77022 times)


  • Newbie
  • Helpful Post Rating: 0
  • Posts: 1
Showtime software and X10 remote
« on: March 02, 2008, 08:52:47 PM »

Anyone have an issue with the X10 remote control included with the Showtime software and Video Sender where it skips the even photos?  When I start a slide show it will show all the odd photos (but flashes the even photo just before showing the next odd picture) and then after showing all of the odd photos shows the even photos.  Thoughts?  Ideas?


  • Newbie
  • Helpful Post Rating: 0
  • Posts: 2
Re: Showtime software and X10 remote
« Reply #1 on: July 28, 2008, 04:46:15 PM »

I am having the same problem. When you just arrow over to the next photo, it flashes #2 and goes right to #3. This has been read over 1100 times, with no answer. Not very encouraging. Obviously others must have this problem, but no solutions. My Harmony used to do this, but you could change settings to "slow" it down.
Logged | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 All rights reserved.