Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[Tuicemen]

Just copy all ahx files from you old drive to the AHP folder on your new drive.
 

[HA Dave]

..... Now, how do I grab my previously created files on my old drive and move them to the new drive?

For years I've kept a flash drive hanging by my HA PC with copies of recent AHP files.

You can search (see below) your hard drive for "ahx" files:  *.ahx

Or look in programs/AHP

[TexasAnimal]

I have had X-10 from the early '80s.  I have used your site for years.  I currently have your software running on my HP laptop with Win 10 and have had no problems.  I have an new HP and am trying to install the software.   I will retire the old laptop.

I have the same problem that tomh (Feb 22, 2018) indicated he had when installing the AHP 3.318 software from the link at the top, "It sticks at attempting to finish installation (blue progress bar)."  In my case I waited an hour and no action.  I got the same results on two previous attempts, but didn't wait between attempts  until I read tomh's experience. I only use lamp and appliance modules with the software.

Your thoughts, please.

[TexasAnimal]

Disregard my previous post, the window just now cleared, and the software works.

[Tuicemen]

Nice hear you up and running.
The installer does take a bit of time to install this is due to there actually being three different processes happening.

[f13dfx]

Re-installed Win7 64bit with AHP 3.318 unregistered.  Copied MyHome.AHX file over to AHP folder along with all my Blue Iris .bat files & BI command.exe file.  Only my Unit A1 MS16A sensor works & Units A2, A3 do not.

Also, when I try to run Blue Iris as a Service, AHP does not execute BI command.

So frustrated I might move to Z-Wave.

[Tuicemen]

What were you running AHP on prior?
Where is AHP folder located?
I can't comment on Blue Iris or BI as I don't run either.