💬General Category > Mac/Linux & Open Source and the X10 Home
CM19A not transmitting???
(1/1)
liderbug:
Raspberry Pi running mochad with a CM19A.
When I
echo "rf e3 on" | nc 127.0.0.1 1099
mochad echos time Tx RF HouseUnit: E3 Func: On
but e3 does not turn on. The TM751 is about 20' away and I have a CM11A plugged in also and it doesn't see the CM19A outgoing command.
Anybody???
Thanks
cal
Brian H:
The TM751 is set to House Code E?
You may want to rotate the House Code Dial on the TM751 a few times. On the chance it is dirty and it is on a different House Code.
If your TM751 has the controlled outlet on it {there was a production run with a hard wired pass through outlet}. If you send an E1 On and an E1 Off. Can you control the TM751s output?
Navigation
[0] Message Index
Go to full version