📸Cameras & Camera Software > Camera General Discussion
Viewing camera(s) WITHOUT receiver
jb63:
I have few wireless X10 cameras and the receiver is broken. Is there a way to view the camera signal without a receiver? I'm thinking such as on an iPad or android device
jb63:
--- Quote from: jb63 on May 17, 2015, 11:08:16 AM ---I have few wireless X10 cameras and the receiver is broken. Is there a way to view the camera signal without a receiver? I'm thinking such as on an iPad or android device
--- End quote ---
The cameras model number is XC18A
Brian H:
No you will need an X10 wireless video receiver. I have not seen any other brand receiver that would use the same four channel frequencies used by X10.
The XC18A was part of the VK69A kit so someone may have added information with that kits devices.
If you had more than one camera and where switching them to the same receiver. You will also have to send an X10 power line to switch their addressable power supplies.
http://kbase.x10.com/wiki/XC18A
jb63:
Thank you. I have the receiver but it's broken (the plastic pivot of the antenna). I can glue it back but it's like performing micro-surgery.
I also have the old LOLA music/video sender/receiver system (with remote). Would the receiver part of Lola work with the XC18A?
Brian H:
I found three different Lola systems.
Do you happen to have the X10 part number on the receiver you have questions about?
Navigation
[0] Message Index
[#] Next page
Go to full version