Please login or register.

Login with username, password and session length

Author Topic: WS267 Not Sending ON Signal  (Read 22049 times)

bt54

  • Sr. Member
  • ****
  • Helpful Post Rating: 0
  • Posts: 93
WS267 Not Sending ON Signal
« on: February 04, 2016, 04:26:11 PM »

I have a macro that is activated when a WS267 is activated.  When I manually turn on the WS267 the signal is NOT displayed in the activity monitor.  From AHP I can turn on the light, the macro fires and the light turns off after the macro assigned time.

C3 - WS267 Address
Macro Trigger C3 ON
Wait 5 Minutes
C3 - Off
Logged
If it doesn't work get a BIGGER hammer!!

Tuicemen

  • Administrator
  • Hero Member
  • ****
  • Helpful Post Rating: 282
  • Posts: 10497
  • I don't work for X10, I use it successfuly!
Re: WS267 Not Sending ON Signal
« Reply #1 on: February 04, 2016, 05:59:13 PM »

Do you mean a WS467 switch?
This switch doesn't send a x10 signal it only has a reciever built in.
Logged
Please Read Topic:
General Forum Etiquette
Before you post!

bt54

  • Sr. Member
  • ****
  • Helpful Post Rating: 0
  • Posts: 93
Re: WS267 Not Sending ON Signal
« Reply #2 on: February 04, 2016, 06:03:19 PM »

You are correct it is a WS467.  I swapped WS467's and the macro finally worked.  Does that sound right since it does not have a transmitter??
Logged
If it doesn't work get a BIGGER hammer!!

Brian H

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 305
  • Posts: 13259
Re: WS267 Not Sending ON Signal
« Reply #3 on: February 04, 2016, 06:12:48 PM »

If it was a X10 WS467 it has no power line transmitter in it. So it should not trigger your macro.
You don't have any X10 device that can send a signal like a Motion Sensor?

The second one was not a Smarthome Model X10WS467D was it. That was an Insteon Togglelinc with the Insteon labels taken off and you programmed it with an X10 address. That one is a two way device and would send an X10 power line signal back on the power lines from a local activation.
Logged

bt54

  • Sr. Member
  • ****
  • Helpful Post Rating: 0
  • Posts: 93
Re: WS267 Not Sending ON Signal
« Reply #4 on: February 04, 2016, 06:23:32 PM »

Brian,
It is a Powerhouse WS467.  I have a test bed with a light and a terminal for connecting switches.  The third switch I tried activated the macro twice in a row.  I'm installing it in a closet as the better half never turns the light off.  If it does not work I'll add a motion detector to the setup.

thanks,
Brian
Logged
If it doesn't work get a BIGGER hammer!!
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.