🛡Home Security > Problems and Troubleshooting
Sc12a
desi77:
Can someone please help me out?
I have had my system for while no issues, now my neighbours got same system it interferes.
It set alarm off at my house. Shouldn't each units have its own frequency.
Please help me out
Brian H:
All the SC12A consoles. Use the same X10 power line frequency of 120KHz and RF 310MHz.
Exactly what is happening?
Their system is triggering an alarm on yous? That should not happen as only Security Sensors and Remotes registered to your console should trigger it.
Or is it that their console flashes your security lighting when triggered? If their console is flashing your security lights. Not the alarm sirens and dialing out. Check that you are not both using the same House Code and Unit Codes. The default is A1 and A2 if both of you are using the default address. It maybe possible they are triggering your security lights.
desi77:
My alarm was set to a1 like you said that's why only Alarm part went off at my home.
Thanks
Brian H:
--- Quote from: desi77 on April 08, 2017, 04:24:34 PM ---My alarm was set to a1 like you said that's why only Alarm part went off at my home.
Thanks
--- End quote ---
Alarm Part?
Did you mean the lights on A1 or A2 flashed when the neighbors alarm sounded or the lights when on and off during an arming delay?
desi77:
When my neighbors alarm tripped my horn went off due to defeat set ups. That is fixed after changing light and house code.
But now different question..my Negihor MS18A doesn't trigger his alarm even though we install it on SC12A. Any suggestions?
Navigation
[0] Message Index
[#] Next page
Go to full version