🖥️ActiveHome Pro > ActiveHome Pro General
Driveway ALERT MACRO using MS16A motion sensor and SC546A chime
edjal:
I have created a macro; Trigger B2( MS16A) On and Time is between 9am and 10:45pm Set Flag 1 Turns Driveway alert (SC546A)Chime on. This works perfectly.
I can not figure out how to add a 30 second delay in between the on command from trigger B2 for the SC546A chime. If someone is still activating MS16A I would like a 30 second delay in between chiming. If anyone has any ideas It would be greatly appreciated. Thank you in advance. Edjal
edjal:
Forgot to mention I use CM15A for transmiter. edjal
Tuicemen:
what is the address of the (SC546A)Chime ?
edjal:
Thank you for your reply the address is B1 for the SC546
Tuicemen:
I have no issue creating the macro.
Click on hide conditions then try to add the delay.
Since it is tricky to add something to the start of an existing macro put the delay in the second spot then drag the set flag down, that will move the delay up.
>!
Navigation
[0] Message Index
[#] Next page
Go to full version