📸Cameras & Camera Software > AirSight Cameras

X 10 Ip, out door camera control issues

<< < (3/3)

Tuicemen:

--- Quote from: Mic_ on May 12, 2018, 12:55:00 PM ---One issue puzzles me regarding the family of PTZ cams like the XX40...These require port forwarding set ups, while the newer IP cams don't. any thoughts?

--- End quote ---
the newer IP PTZ cameras still need port forwarding if you use the web interface.
If you use the IP camera app port forwarding isn't needed as the software uses P2P
I'll have a look for the EasyN IP camera software but I suspect if the x10 camera software is failing it will to.
Have you tried connecting with the Ethernet cable to be sure it isn't the cameras Wi-Fi that failed?

Mic_:
Thanks for the knowledge and patience. The failure I mentioned does not happen all the time. Things will work for a while, then fail (Kinda freeze) then the camera will speed through pan, tilt, and zoom mode before parking itself on the bottom of its travel. Once I reset the power, it would work again. I have much better luck with it controlling from my smart phone. Thanks again

Navigation

[0] Message Index

[*] Previous page