📱X10 WIFI > 🗯General Discussion
Difference Between WS and LM in the app
Knightrider:
Anyone else notice that a lamp module has 12 dimming steps, and the wall switch has 24?
I didn't know there was a hardware difference.
SkipWX10:
Hadn't noticed this until you mentioned it....never looked that closely. I always assumed that either was infinitely dimmable since you can set any percentage in AHP.
Knightrider:
So, is this a quirk or a bug?
Tuicemen:
--- Quote from: Knightrider on May 03, 2018, 11:14:10 AM ---So, is this a quirk or a bug?
--- End quote ---
I'd say neither the lamp modules handle dim differently then the switches.
Switches allow for a wider dim variance however with LEDs that isn't as noticeable.
I'm not sure why the developer choose to code this way as most just do a % value.
dhouston:
There's never been much logic or consistency to X10 Dim/Bright signals. See...
https://www.laser.com/dhouston/micro-dim.html
http://www.heyu.org/docs/Effect_of_Phase.txt
https://www.laser.com/dhouston/preset.html
Navigation
[0] Message Index
[#] Next page
Go to full version