Contact | X10.com
Please login or register.

Login with username, password and session length

Author Topic: Motion Sensor/Wall Switch Problem  (Read 1998 times)

chad

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 3
Motion Sensor/Wall Switch Problem
« on: September 04, 2005, 05:59:31 AM »
I set up a motion sensor to activate
overhead lighting via a wall dimmer switch
(WS467).  The switch is turning on when
motion is detected but it is setting the
output to 0% so I get no light.  How can I
get it to set it to 100% or preferrably
even a lower setting when it detects motion?
Logged

Brian H

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 305
  • Posts: 13260
Re: Motion Sensor/Wall Switch Problem
« Reply #1 on: September 04, 2005, 07:59:34 AM »
What is the motion sensor triggering? A
macro in the AHP interface [cm15a] or
directly on the wall switches address
through a tranceiver [cm15a's receiver or
maybe a TM751]? Remenber by default a motion
sensor after one minute of no motion. Sends
a off command.
Logged

chad

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 3
Re: Motion Sensor/Wall Switch Problem
« Reply #2 on: September 04, 2005, 01:41:02 PM »
I saw your post in the other forum.  I
checked the hardware settings and found
that it must default to none for tranceived
codes.  I changed it to auto and it seems
to be working fine.  Thanks for the help!
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.