🖥️ActiveHome Pro > iWatchOut/iWitness
Recroding Macro Not Working
julian:
My recording Macros are still not working.
After 2 minutes, which is the delay I set,
the macro causes AHP to crash. Also, if I
change the macro to take snapshots every 5
seconds and have a delay of only 10 seconds,
it loops continuously. I thought these
problems were supposed to be fixed? Is anyone
else seeing these issues?
Tuicemen:
julian : which OS are you running on? I
couldn't get them to run in 98 with the
beta. Can't test that now with 98 but they
work on my XP pc.
JimC:
Julian,
I have a macro set up to record stills at 5
second intervals for 2 minutes when
triggered by a motion sensor. Just tried it
and it seems to be working fine. I am
running Windows XP Home SP2.
julian:
I am running XP Home, with the latest version
of AHP 1.385.
Jim - have you tried to use the Video Record
function in your macros? I tried the macros
just the way you have it and it still loops
as if it ignores the flag and restarts as
soon as motion is detected again (within the
2 minute period, when the flag should prevent
it from restarting).
JimC:
Julian,
No I have not tried the video record
function only the video stills. I am sorry
about the previous post where I stated that
the macro was triggered by a motion sensor.
It is actually triggered by a IR beam that
is reflected back to the sender by a
reflector. (can’t remember what these units
are called) It is a very narrow beam unlike
a motion sensor and my walking past it
would have only caused it to trigger the
macro once. Sorry, this information is not
very useful in your situation.
I have used flags in other situations with
motion sensors that turn on lights and dim
them and the flags seem to be working
there. I have not tried them with the
cameras yet.
Navigation
[0] Message Index
[#] Next page
Go to full version