🖥️ActiveHome Pro > iWatchOut/iWitness
Shortest Cam Scan Period
WaltK:
When I run Multiview on same system as AHP
I can use very short scan periods when
scanning automatically between cams. 5
Seconds works great, even when AHP is up
and CM15A is supporting it and Multiview
traffic. It seems that the shortest period
I can set in iWitness is 15 seconds per
snapshot. How do I make it shorter?
Helpful hints:
Do direct entry: Highlight the value entry
i.e. the 15 and key in 05
tony:
It would be great to be able to take it down
to at least 03 seconds for both between
cameras and between still shots. in fact the
still shots should a time increment from the
switch time to each camera. i.e. upon switch
to or turn on the respective camera +2
seconds.
X10 Pro:
We'll make it so the arrow buttons allow you
to enter the minimum value. I'll see if we
can make it less than 5 seconds, too.
tony:
X10 Pro: Thank you.
Navigation
[0] Message Index
[#] Next page
Go to full version