Topic: flags won't set (Read 2975 times)

kenny · « **on:** April 15, 2005, 06:12:35 PM »

New for today! Flags can't be set anymore!
These are critical for my macros and they
stopped working today.

Any ideas?

Kenny

X10 Pro · « **Reply #1 on:** April 15, 2005, 06:34:23 PM »

There is a problem in some circumstances
where the Status Report isn't displaying the
correct flag data. Try triggering a macro
that sets a flag, and then trigger a macro
that uses that flag as a condition -- it
should work.

kenny · « **Reply #2 on:** April 15, 2005, 07:06:00 PM »

That's exactly how I know that the flag isn't
set. I ran a macro tht sets a flag and then
a light turned off via a macro that is
conditioned on an off signal from a motion
but only if flag 2 is off. Status report
show flag 2 off and everything behaves as if
it really is. The flag isn't being set.

Kenny

X10 Pro · « **Reply #3 on:** April 15, 2005, 07:09:13 PM »

Are you using the "Run Macro" button in the
software, or triggering with a remote control?

kenny · « **Reply #4 on:** April 15, 2005, 07:20:48 PM »

I originally ran the macro from the software.
I just tried it with the RF switch I usually
use and the report noted the flag as set.
That's wierd because usually when all else
fails the software button are usually the
last to fail.

Kenny

X10 Pro · « **Reply #5 on:** April 15, 2005, 07:31:55 PM »

The "Run Macro" button doesn't currently set
flags, but that will be fixed in the next update.

News:

Author Topic: flags won't set (Read 2975 times)

kenny

flags won't set

X10 Pro

Re: flags won't set

kenny

Re: flags won't set

X10 Pro

Re: flags won't set

kenny

Re: flags won't set

X10 Pro

Re: flags won't set