Contact | X10.com
Please login or register.

Login with username, password and session length

Author Topic: Clear Interface Not Working  (Read 2799 times)

keith

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 1
Clear Interface Not Working
« on: February 09, 2006, 09:48:57 PM »
I am findinG ahp quite buggy.  It doesn't
seem possible to clear the interface. After
Issuing the command, interface still shows
all timers macros and prefences loaded.  even
after unplugging and removing batteries!
Macros run unreliably and I notice that
spurious commands are being sent and I assume
it is the USB interface that is doing it--but
I cannot figure out how to stop it. Also old
ah1.42 (which kind of sucked) seemed to run
more reliably and issue commands thru serial
interface more powerfully than this one....
Logged

X10 Pro

  • Hero Member
  • *****
  • Helpful Post Rating: 23
  • Posts: 1416
Re: Clear Interface Not Working
« Reply #1 on: February 10, 2006, 12:31:35 PM »
The statistics show you the what would be
used by your currently loaded AHP
configuration, not what is in the interface
memory. That's what the original ActiveHome
did, too. Clear Interface Memory is working fine.

In what way are macros running unreliably?
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.