Please login or register.

Login with username, password and session length
Advanced search  

News:

The X10Hub (PiX10Hub) is here! Created by the Community, for the Community.:)% #:)

Author Topic: blank pic when starts to record  (Read 8347 times)

Going Bonkers

  • Guest
blank pic when starts to record
« on: December 20, 2004, 09:00:50 PM »

 Finally I have everything working right,
well almost to many hours involved to stop
now. My problem is when my sensors detect
motion the screen will go blank on my
monitor and that is what it records. This
happens on all three of my cameras. 2-xcam2
and one lowlight all wireless. Also when I
flip thru from one cam to another with the 8
unit scan cam remote it will go blank on
monitor, sometimes within a few seconds
sometimes in a minute or two. Is there some
kind of sleep mode and if so why will the
camera not kick back on. Would be thankfull
for any answers or even suggestions. Also
can be reached at liener@aol.com
Logged

WinS

  • Sr. Member
  • ****
  • Helpful Post Rating: 14
  • Posts: 106
Re: blank pic when starts to record
« Reply #1 on: December 21, 2004, 05:55:48 PM »

GB
Have you accounted for the motion sensor's
"off" command which occurs one minute (by
default) after it is triggered on?  That's
about all I can offer without knowing more
about your application.  I have a MultiView 4
cam system with it's own inherent problems.  
Logged

CT

  • Guest
Re: blank pic when starts to record
« Reply #2 on: December 27, 2004, 01:42:14 PM »

I suggest that you get the Xcam2 Instant-ON
cameras.  It takes sometime to warm-up a
camera in order to see pictures.  By switch
from one to the next with the older xcam,
you'll see some period of blank.
Logged

Brian H

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 289
  • Posts: 12719
Re: blank pic when starts to record
« Reply #3 on: December 29, 2004, 07:55:28 AM »

If your cameras are not the instant on ones,
when the power is switched on the whole
electronics has to start powering on.
Including the sensor used to get the light
to video. The instant on models have all but
the RF transmitter on all the time and just
switch on the RF when activated. Easy way
too tell. Look at the power conncetor from
the wall brick. If it is a connector like a
1/8" stereo plug it is instant on as the
third connection has power for the camera
and the other goes on and off for the RF
section. Blank video untill the sensor
charges up is a normal thing.
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.