Please login or register.

Login with username, password and session length
Advanced search  


The Buster PiX10Hub is here! Created by the Community, for the Community.:)% #:)

Author Topic: Motion Detector setting off console at entry  (Read 7455 times)


  • Newbie
  • Helpful Post Rating: 0
  • Posts: 3
Motion Detector setting off console at entry
« on: June 30, 2004, 11:33:58 AM »

I was just testing out the security system,
and i set everything on a delay so that i
can get out of the house for a minute, and
so i can enter the house i believe it's 30
seconds, but i have to pass threw a motion
detector to get to anything, isn't there
supposed to be a delay on motion detectors
when you first enter the house? Any help
would be appreciated.


  • Guest
Re: Motion Detector setting off console at entry
« Reply #1 on: July 04, 2004, 12:02:34 PM »

On the motion detector set the slide switch
to position 2 to trigger only after two
movements have been sensed. This might give
you enough time to enter and disarm the
Logged | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 All rights reserved.