Please login or register.

Login with username, password and session length

Author Topic: Multiple commands from one event  (Read 3380 times)

terryk

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 4
Multiple commands from one event
« on: January 03, 2006, 01:10:14 PM »

I have a basement with multiple unswitched
lights (the pull chain type)and one switched
light right at the bottom. Is it possible to
use an x10 lightswitch with some socket
rockets to make them all turn on from the
one switch?
Logged

Brian H

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 305
  • Posts: 13259
Re: Multiple commands from one event
« Reply #1 on: January 03, 2006, 04:30:34 PM »

Don't know if X10 has a switch that also
transmits an X10 signal when actuated. I
have seen other brands that do.
Logged

kk

  • Full Member
  • ***
  • Helpful Post Rating: 1
  • Posts: 41
Re: Multiple commands from one event
« Reply #2 on: January 03, 2006, 06:25:34 PM »

Seems like you could maybe use a little
keychain remote (or another kind) and have
the remote trigger a macro to flip all the
switches at the same time.
Logged

tommy

  • Jr. Member
  • **
  • Helpful Post Rating: 0
  • Posts: 14
Re: Multiple commands from one event
« Reply #3 on: January 04, 2006, 09:54:20 AM »

Could you use a motion detector that also
has dusk to dawn sensor built into it to
detect the status of the swithed light and
then send the codes to the socket rockets?
Logged

terryk

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 4
Re: Multiple commands from one event
« Reply #4 on: January 04, 2006, 05:14:06 PM »

Thanks guys. I think all of that is possible
but I would rather rewire than mess with
keychains and motion sensors (I would have
to have multiple sensors in the basement
then) It seems like a product opportunity
for x10 though. Turn on one light and
have 'virtual wiring' to others.
Logged

kk

  • Full Member
  • ***
  • Helpful Post Rating: 1
  • Posts: 41
Re: Multiple commands from one event
« Reply #5 on: January 05, 2006, 10:36:14 AM »

I'd still just hang a keychain remote on a
little hook where the light switch would
be...and be done with it!
Logged

ptc

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 4
Re: Multiple commands from one event
« Reply #6 on: January 07, 2006, 06:25:59 PM »

Set all the socket rockets to the same code,
like a1.  Then any controller will turn them
all on and off.  x-10 makes a remote switch
you could attach right to your wall.
Logged

Brian H

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 305
  • Posts: 13259
Re: Multiple commands from one event
« Reply #7 on: January 07, 2006, 07:05:34 PM »

Smarthome 2876SB Icon ON/OFF switch. Can
have a Primary X10 address programed into
it. When turned on or off it sends the on
off code back on the power line. Like to all
the socket rockets. One thing. It does need
a neutral wire in the switch box to work.
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.