Please login or register.

Login with username, password and session length
Pages: 1 2 [3]

Author Topic: Active Home Pro - some appl mods not working?  (Read 35664 times)

Tuicemen

  • Administrator
  • Hero Member
  • ****
  • Helpful Post Rating: 282
  • Posts: 10497
  • I don't work for X10, I use it successfuly!
Re: Active Home Pro - some appl mods not working?
« Reply #30 on: December 07, 2006, 01:20:13 PM »

dave w: the problem isn't that transceivers weren't being identified in Dave G setup
Just one of the  problems was they were not configured properly! ;) :D ;D
And this wasn't all brought out in the OP! ;) :D ;D
Logged
Please Read Topic:
General Forum Etiquette
Before you post!

Dave G

  • Jr. Member
  • **
  • Helpful Post Rating: 0
  • Posts: 13
Re: Active Home Pro - some appl mods not working?
« Reply #31 on: December 09, 2006, 05:53:51 PM »

just wanted to give an update...

I have been very busy and haven't had too much time to spend doing all the playing around that i wanted to, but...

i added a transceiver module to AHP for all my house codes (that have a transceiver).  That still didn't seem to make it 100% better, so i swapped out / moved around some modules.  I am not saying that it's working properly, but everything did come on tonight like it's suppose to.  I will have to see how the turning off part goes.

Over the last couple days, it seemed pretty inconsistent about what was or was not working.  If it starts fouling up again, i wonder if it could be that I am using some older modules / transceivers.  If i run into problems again, i will have to MAKE the time to try and figure it out.

Thanks again for all the responses, just sorry that I haven't been able to dedicate time to this and get back to you all quicker...
Logged
Pages: 1 2 [3]
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.