X10 Community Forum

🛡Home Security => Problems and Troubleshooting => Topic started by: peg-leg on July 05, 2010, 12:38:50 PM

Title: sh624 remote won't arm/disarm the system
Post by: peg-leg on July 05, 2010, 12:38:50 PM

All of the sudden, both my security remotes stopped working.  The 4 light control buttons still function properly, but the arm home/away functions don't work.  It happened to the first remote a couple nights ago.  The 2nd one this morning.  I have gone through the re-install procedures multiple times with no luck.  Changed to new batteries as well.

I noticed that during the install procedure, once I've registered the remote and  gotten the confirmation beep, when I slide the switch back to run 1 or 2, the record/busy light stays lit for around 10 seconds before going out.  Not sure if this is standard or is being cause by an error.

As of now, I cannot use the sytem in the arm home mode.  My keychain remotes  still work properly

Please help.

Thanks!

Title: Re: sh624 remote won't arm/disarm the system
Post by: peg-leg on July 07, 2010, 12:35:54 AM

Solved this issue by powering down the entire system and re-installing.

Title: Re: sh624 remote won't arm/disarm the system
Post by: tom j on July 25, 2010, 04:00:55 AM

Make sure you keep an eye on it and when you did the reinstall did you generate new security codes for everything, strange things can happen if you don't.

Tom j.