X10 Community Forum
📸Cameras & Camera Software => Legacy non Wi-Fi X10 Cameras => Camera General Discussion => Wireless Cameras(non IP) => Topic started by: moeman on July 03, 2006, 05:11:48 PM
-
I just add a second Vanguard Camera and it seems to be interfering with the the signal from the first Vanguard Camera. I have tried different settings within the Vanguard software and still no luck. It only works if I disconnect the first vanguard camera or vice versa.
Can someone please tell me what I am doing wrong.
-
Can't say about the software, but only one wireless camera can be on at a time or they interfere with each other.
How are the House and Unit Code settings on the addressable power supplies set?
-
The first Vanguard camera is set to House Code A, Unit Code 1 and the second Vanguard camera is set to House Code A, Unit Code 2.
Did you say that 2 Vanguard cameras cannot be connected at the same time? Does this mean that I can only install one otherwise it will cause problems?
-
No you can have 4 without added requirements. Only one can be on at a time. I am not farmilliar with the Vanguard model, but have used other ones. Basically the power supply for the camera has a addressable on/off function. They work in groups of four. House Code and Unit 1-4;5-8;9-12 and 13-16. A powerline ON to lets say your A1 should automatically turn off A2 A3 and A4.
I may brave the X10 sales site [I do HATE those stupid talking messages] and see the Vanguards users manual.
May have more data later.
Later:
Did you set the second cameras address as shown in the manual [yes I did find it]. Moving the program switch 'program' and using the remote to set it to C2? Manual said you can use up to four so maybe it is a setup problem. Below is the Knowledgebase address where you may fine added help.
http://kbase.x10.com/wiki/Main_Page