X10 Community Forum

🖥️ActiveHome Pro => ActiveHome Pro General => Help & Troubleshooting => Topic started by: coraldaze on November 09, 2007, 02:39:42 PM

Title: Wireless a/v model mk11a
Post by: coraldaze on November 09, 2007, 02:39:42 PM

Hi,

I am trying to install the above modules and find I cannot get audio or video.

I have downloaded software many times , have changed the channel info on each module. checked power supplies,etc..

Do I need to install seperate audi/video cables into the unit from pc???

I thought USB cable would suffice for the audio/video sigs ???

Thanks

Hans

Title: Re: Wireless a/v model mk11a
Post by: HA Dave on November 10, 2007, 09:02:56 PM

Here are the directions for setup (http://kbase.x10.com/wiki/Lola_Direct_Connect_Kit_Setup)(<that's a link).

I hope that's helpful. I think... the kit you have assumes you have an RCA video out from your PC's video card. If you don't.... X10 does have a sender unit that connects to the VGA post of a PC.

If your connected correctly... and still not getting a signal to your TV... check your PC's video setting.