📱🖥️PiX10Hub > 🧞 ⛑HomeGenie Help

How to add ds10 security sensors to HG 1.3

(1/3) > >>

spacenut:
Hi
I was given a bunch of da10 security sensors,what I would like to know is, how do I add them to HG 1.3?

Brian H:
What RF receiver or transceiver  are you trying to use with the DS10A Security Sensors.
The security message is different than other X10 RF devices.
Some may not process them.
My CM15A would with one of the software plug in but my WGL  W800RF32 generated an Unrecognized or Corrupt Packet message.
The message also had different contents in the messages before and after I did a Generate a new security code on the test DS10A.

spacenut:
Hi Brian
I am using a cm15a, I installed one sensor in ahp & ahp confirms it, the thing I am having is setting that sensor up in homegenie?

Tuicemen:

--- Quote from: spacenut on October 22, 2023, 08:52:12 AM ---Hi
I was given a bunch of da10 security sensors,what I would like to know is, how do I add them to HG 1.3?

--- End quote ---
You need to enable x10 RF in HG then Hg should see the sensors when you press the test button

spacenut:
Thank you for the response but were do I find how to enable x10RF in 1.3-stable-19? I don't know where to find it?

Navigation

[0] Message Index

[#] Next page