X10 Community Forum
🛡Home Security => Problems and Troubleshooting => Topic started by: dchan5 on August 04, 2008, 09:04:07 PM
-
Hi,
I just installed my security system, and everything is running smoothly, except for my security remote. When I try to arm my system using it, the console just starts beeping for several minutes. I made sure that all my sensors and zones were ok but I still have this problem. I saw that the remote has a setting for min and max, but the same thing occurs for both settings. When I switch the tab to min, it still beeps for several minutes. Is there a way I can fix this, or is my security remote defective? Thanks.
-
While it's beeping, hit the bypass button. If it stops and arms, it's because you're bypassing a sensor it can't cerify as closed. The blinker should tell you which one. Could be a distance thing...
-
I don't think that was the problem, as I can still arm and disarm by using the keychain remotes. The keychain remotes work fine in disarming and arming the system, but I am having problems arming with the security remote.
-
Well then - You may have to start over. I had some similar problems - 4 Keychains, 2 Security remotes & 2 macros.
I believe you can only INSTALL 8 remotes, and although the DS7000 will beep to indicate installation, it really won't. And before you say you haven't installed 8 remotes, have you re-installed any without clearing the DS7000 by no-power & no-battery?
Just trying to help - and I had a similar problem until I cleared and re-installed everything.
-
yea, I tried to reinstall everything, but I still have the same problem. It seems like the MIN setting is not working because it will still arm after a minute of beeps. Is there a way to fix it so that it will arm instantly?
-
I think I read something about having to use a security remote to arm in the MIN setting at least once. Do you have one?
-
yes, I have a security remote that is suppose to be able to arm in the MIN or MAX setting...but I am having trouble getting it to arm in the MIN setting.
-
yes, I have a security remote that is suppose to be able to arm in the MIN or MAX setting...but I am having trouble getting it to arm in the MIN setting.
It's definitely the security remote I don't think you have it pushed over far enough, I had the same problem when I first got mine, either that or it's defective.
Tom j.