X10 Community Forum
🖥️ActiveHome Pro => ActiveHome Pro General => Topic started by: me too on April 22, 2005, 09:35:15 PM
-
Win 98SE
Diagnostic CM15a
I had upgraded to 3.186 but havent pluged in
the CM15a untill this evening. The CM15Aa
kept installing with a generic USB driver and
then would not be picked up by AHP as
connected. I had to delete the generic USB
device, then take the batteries out of the
CM15a and replug it in. Then the new USB
driver installed.
I have been running unconnected for weeks.
only have a couple of simple macros and
timers with one motion sensor. No complaints
with the diagnostic unit so far.