X10 Community Forum

💬General Category => General Discussion => Topic started by: LarryG on January 08, 2007, 10:58:32 PM

Title: Question about Module Status choices
Post by: LarryG on January 08, 2007, 10:58:32 PM

In Advanced Macros, if I edit the Module Status ("If these Modules are On") the choices are limited to a single house code, that is C1 to C16. I don't want a 'C' house code but rather a 'D' house code. How do I make the Module Status show house codes D1 through D16 ?

Title: Re: Question about Module Status choices
Post by: Dan Lawrence on January 08, 2007, 11:06:27 PM

Modules, both lamp and appliance can access all housecodes from A-P and addresses from 1-16.  They are set by the code wheels. Socket Rockets have no code wheels, but can be set to the same ranges as modules by usiing a M460 and a lamp.

Title: Re: Question about Module Status choices
Post by: Puck on January 08, 2007, 11:17:47 PM

Quote from: LarryG on January 08, 2007, 10:58:32 PM

How do I make the Module Status show house codes D1 through D16 ?

Under Tools / Hardware Configuration, Set your Monitored House Code to 'D'.

Title: Re: Question about Module Status choices
Post by: LarryG on January 08, 2007, 11:25:05 PM

Thanks Puck! That was the "magic answer". Much appreciated.