X10 Community Forum
🔌General Home Automation => Automating Your House => Troubleshooting Automation Problems => Topic started by: LostDog88 on October 27, 2018, 06:40:05 PM
-
Why do some of my sensors show a tamper in black letters below the status of the sensor? They work fine, they all have covers and they covers are closed...
-
Do you know what their part number is? There where new models when the SC1200 was being sold.
Security sensors. I know they check in about every hour. If it was four hours and no check in. Would generate a problem zone indication if check in was missed continuously.
The Tamper was as you expected the sensor cover was opened or not tightly closed.
-
They are DS12A's. They have covers. The covers are on and tight.
I don't know about the checking in part. I just noticed this all happening a couple days ago.
I know if I open a door the SC1200 chimes immediately.
One time I had one that had a problem with it's cover. Cats...long story I won't bore you with, but it had a tamper warning in the widget that was bright red instead of black.........???
-
Thanks for the update.
If the SC1200 is not showing a Tamper or Zone problem. The DS12A sensors are probably OK.
Since I don't use or have HG. I don't have any idea what the indication means.
-
Could black mean OK while red means TAMPER?
-
That is exactly what I thought.
But not all sensors show the word "tamper"?????