X10 Community Forum
💬General Category => General Discussion => Topic started by: frontshadow on September 16, 2015, 04:00:03 PM
-
Hello forum...
I'm a newbie to X10. A couple of weeks ago I picked up an older X10 console (Ps561 I think) and some devices.
I downloaded the manuals for about everything, reviewed them and installed the system while testing. I've
managed to get everything running according to the instructions/manuals with the exception of turning off
(disarming) the alarm after it has been triggered. Try as I may with either of two remotes or a FOB, the console
just keeps beeping away (along with the remote siren) for the full 4 minutes.....then stops. The console reports
the zone of the alarm trigger and seems to do everything else right (that I have tried with the window/door, PIR,
Sirens, etc....)....expect that I cannot not turn off the alarm. I'm am attempting to use the remotes, using
the DISARM button(s)......nothing happens.....Please, what am I missing?
Thanks in advance to someone, anyone..... -:)
-
Have you installed all the remotes and flobs so the console recognizes them?
-
Thanks for the reply....I have two remotes and one fob.
All have been installed and seem to work OK
(all can ARM/DISARM) the system unless it unless triggered by a zone (have two window/door sensors
Set up for testing). After the console siren starts to sound and lights flash, I cannot stop the alarm
With any remote nor from console. To totally clear the
System I have to remove the battery, AC power and let sit
For a few min????
-
If the Zone that was violated LED is flashing.
Try the Troubleshooting tip on page 25 of the manual. Try Arm then Disarm.