X10 Community Forum
🛡Home Security => Home Security General => Topic started by: Ron See on July 26, 2004, 05:24:09 AM
-
My PS561 Wireless Security Console alarm
keeps beeping at a slow rate about 5 times
every 45 minutes or so. It then stops. It
does it whether the system is armed or
disarmed. Any suggestions as I don't see
anything in the manual about the cause.
-
Same here, I ended up reinstalling all
sensors..
-
yes, mine was doing that because I
installed NIMH aa batteries which do not
have suficient voltage apparently. I
reinstalled the units again with new
regular 1.5 v batteries and the problem was
resolved. NIMH only have about 1.2 v at
full charge.
-
Mine began doing this today. I just installed
brand new Panasonic 1.5 volt Alkaline
batteries in all sensors 5 weeks ago. Any
ideas from anyone? It will do it, and yet I
can immideately arm the system and there is
no indication anything is wrong. What gives?
-
OK, an update.
Seems I was not holding the Bypass button
down when checking zones 9 through 16. I now
see zone 9 blinking. I replaced the batteries
in sensor 9. No help. I suspect the batteries
went totaly dead after only 5 weeks. I
reinstalled zone 9 sensor, which now became
number 14. My question is this, What happens
to zone 9 now? Will the base unit continue to
beep 5 times because zone 9 sensor does not
report? Do I have to reinstall everything now
to eliminate this 5 beep notification? I
noticed that when I try to ARM the system
now, I get the BEEP BEEP BEEP ............
until I push Bypass. Is this because zone 9
is gone? I hate to think I will have to
reinstall 5 motion sensors and 8 window
sensors every time a battery goes dead.
Anyone help here?
-
Looks like you will have to reprogram
everything :-(
That never happened to me in over 8 years.
But I have less than 9 sensors, so I always
noticed when a light was slowly blinking -
which is the signal that abattery should be
replaced before it is totally depleted.
On the other hand, I got the fast beeps
whenever I try to arm with a low battery.
I'll remember this.
-
I think you hit the nail on the head jc. If
you have more than 8 sensors, you will NEVER
know when a battery is about to go, until it
goes. I am puzzled by the short batter life
in the sensor which went, those were brand
new batteries.
-
Well here we are again, same problem happened
again today. What is going on. Is there any
possible way to stop the base unit from
beeping 5 times every half hour due to zone 9
failure?
Man! I really don't want to have to
re-program this thing again!