X10 Community Forum
📸Cameras & Camera Software => Legacy non Wi-Fi X10 Cameras => Camera General Discussion => Wireless Cameras(non IP) => Topic started by: paulsaun3 on March 20, 2009, 11:54:36 PM
-
Will I have interference if both of these units are active at the same time? It appears they are are on the same frequency.
-
Probably you will. Have you tried varied channels for each unit? Like maybe camera on A and video sender on D.
-
I'm considering purchasing one of each of them. If the separate channels have worked for others, I'll give them a try. I assume the three camera setup uses a channel for each camera?
Brian, thanks for the comment.
-
Hope I'm not butting in but I'll try to explain. The 3 cameras will be on the same frequency code. (A, B, C, D) And will have their own House and Unit code. (C1, C2, C3)
Then you could try a different Frequency code for the Video/Audio sender. (A, B, C, D)
Here is an example: camera 1 is C1, camera 2 is C2, camera 3 is C3. All the camera frequency codes set to "A".
The Video/Audio sender would then have to be on a different frequency code of "B" or "C" or "D"
Hope this helps.
-
Thanks,
That helps a lot, ordering today.
-
As hawk 1 pointed out. The House Code A-P used to turn the cameras on and off is not the same as the transmitting channels A-D.
-
The set up hawk 1 gave you does work!!!
This is how I have mine set up ( with 9 cameras) , and it works great