X10 Community Forum
🖥️ActiveHome Pro => ActiveHome Pro General => Help & Troubleshooting => Topic started by: rdolmat on September 18, 2010, 09:28:55 AM
-
Hi folks.
Here is my issue:
I have a lamp set to B1. I have a credit card remote (KR22A) also set to B1.
I press the on button (#1) on the remote....ActiveHome Pro shows ONLY THE SWITCH going up on the lamp, but the DIM slider stays at the bottom...hence the light never turns on.
:-\
any ideas?
thanks!
-
Do you have the CM15A set up to transceive house code B? (Tools/hardware configuration)
-
Lets try something:
Under the hardware configuration, set the transceived house codes to specific and make sure that "B" is ticked.
This has worked in the past for some users.
Knightrider edit: Dave W posted under me, but additional info provided in my post. Sorry for the redundancy.
-
Lets try something:
Under the hardware configuration, set the transceived house codes to specific and make sure that "B" is ticked.
This has worked in the past for some users.
Knightrider edit: Dave W posted under me, but additional info provided in my post. Sorry for the redundancy.
ah dang!!! that was perfect!! such a simple solution....thanks so much to both of you!!
:)% >!