X10 Community Forum
🖥️ActiveHome Pro => ActiveHome Pro General => Help & Troubleshooting => Topic started by: rodmeeker on December 13, 2006, 06:13:31 PM
-
I have several timers controlling three rooms. All work except one (my Christmas lights). AHP will not turn on (note I have 5 modules all on the same code (e1) scattered throughout the house -- and it will not turn ANY of them on). The RF transmitter will turn them on and off (note using the same CM15A trans in the same outlet -- so I think that rules out noise and the outlet). I also have a wired control module (from Radio Shack) in another outlet with no problems. In the timer advanced I have tried the 'repeat' option with no luck.
What can be the deal? Should I try another code?
Thanks,
-Rodney
-
I had a similar problem with two timers, one turning on some landscaping lights, and one for a small Christmas tree. They were connected to appliance modules, but I had loaded them as lamp modules. Others helped me with two suggestions: first was to load the modules properly as appliance modules (doh!). The second suggestion was to go to Tools > Preferences > Macro Options and click "Issue On in place of Bright 100%."
Loading the modules in as appliance modules corrected everything for me. The strange thing was that if I manually turned on the lights in question, the timers would turn them off perfectly well, so I had the same problems you're having. If you truly have lamp modules, try the "Issue On" command. Hope it all works out for you!
robster