📱X10 WIFI > 🐞X10 WIFI App problems or bugs

Power loss?

<< < (2/3) > >>

brobin:

--- Quote from: bubbah on September 22, 2018, 02:34:23 PM ---Questions about power loss recovery:

1.  Is automation of sync after power loss or even sync script on a schedule planned?

2.  Will the device live peacefully behind a UPC device?

--- End quote ---

The WM100 should be peaceful enough but be aware that most UPS devices have EMI filters that may unacceptably attenuate X10 transmissions.  Doesn't hurt to try though!

Brian H:
I would also suspect the UPS AC power line filter will absorb the X10 power line signals.
I know owners of an ISY994i interfaced through a 2413S PLM to the power line. Loose their power line commands behind an UPS. But since the PLM is Dual Band. It uses RF to the closer Dual Band modules that then pass the signals on by RF and power line.

normd:
I’m not sure what happened, but my WM100 forgot to turn on my timers around 7pm last night but it did fine the night before. It sent the off signal at the right time hours later. Ideas?

Tuicemen:
Are you able to view the WM100 history?
If so does it show a on signal being sent?

normd:
Nothing in the history for 7pm last night but on signals sent the previous night. Off signals sent both nights.

Navigation

[0] Message Index

[#] Next page

[*] Previous page